Canon ZR960 Instruction Manual page 51

pause ( ) mode for 4 minutes 30
seconds. To resume the operation press
Start/Stop (when recording) or push the
joystick ( ) toward
playback).
Recording
Image will not appear on the screen.
- Set the camcorder to
( 23).
[SET THE TIME ZONE, DATE AND TIME]
appears on the screen.
- Set the time zone, date and time (
- Replace the backup lithium battery
( 17) and set the time zone, date and
time.
Start/Stop
Pressing will not start recording.
- Set the camcorder to
( 23).
- Load a cassette (
- Tape reached the end ("
on the screen). Rewind the tape or
replace the cassette (
- Cassette is protected (
screen). Change the position of the
protect switch (
Camcorder will not focus.
- Autofocus does not work on that subject.
Focus manually (
- If you are using the viewfinder, adjust it
with the dioptric adjustment lever (
- Lens is dirty. Clean the lens with a soft
lens-cleaning cloth (
tissue paper to clean the lens.
Sound is distorted.
- When recording near loud sounds (such
as fireworks or concerts), sound may
become distorted.
Viewfinder picture is blurred.
- Adjust the viewfinder with the dioptric
adjustment lever (
Playback
During playback there is video noise.
- Video heads are dirty. Clean the video
heads ( 2).
/ (during
mode
20).
mode
21).
END" appears
21).
flashes on the
55).
32).
23).
56). Never use
23).
Playback does not start.
- Load a cassette (
- Set the camcorder to
( 27).
- Tape reached the end ("
on the screen). Rewind the tape (
No sound from the built-in speaker.
- Open the LCD panel.
- Speaker volume is turned off. Adjust the
volume with the [SPEAKER VOLUME]
setting ( 27).
Image will not appear on the TV screen.
- Check again that the camcorder is
properly connected to the TV (
Tape is running, but image will not appear
on the TV screen.
- TV/VIDEO selector on the TV is not set to
VIDEO. Set the selector to VIDEO (
- Video heads are dirty. Clean the video
heads ( 2).
- You attempted to play back or dub a
copyright protected tape (
playback/dubbing.
Editing
Cannot record with this camcorder video
input from an external video device
connected using a DV cable.
- Wrong signal standard. Refer also to the
instruction manual of the connected
device.
Additional Information
21).
mode
END" appears
21).
39).
40).
42). Stop
• 51