Warming Up The Engine; Forward, Reverse, And Acceleration - TOHATSU M 4C Owner's Manual

32
ENGINE OPERATION
ENOM0004B-0

3. Warming up the engine

ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check por t
during warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
below 5°C (41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
7
1. Cooling water check port
ENOM0004A-0
Engine speeds
Idling speed after warming up.
Trolling speed
(in Forward)
-1
850 min (rpm)
CAUTION
-1
(rpm) :
ENOF02124-0
Idling speed
(in Neutral)
-1
1000 min (rpm)
ENOM00046-A
4. Forward, reverse, and
acceleration
ENOW00037-0
WARNING
Before shifting into forward or reverse, make
sure that boat is properly moored and out-
board motor can be steered fully to the right
and left. Make sure that no swimmer(s) is
ahead or astern of the boat.
ENOW00038-A
WARNING
Attach other end of emergency stop
switch lanyard to the operator's PFD (Per-
sonal Flotation device) or arm and keep it
attached during cruising.
Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
Arrange the tether so that will not be
caught by any object when pulled.
Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop of
engine can cause loss of control of out-
board motor. Rapid loss of engine power
can lead to falling down or causing pas-
senger(s) to be thrown overboard.
ENOW00042-0
WARNING
Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
Do not shift into Reverse during cruising,
or control may be lost, falling down or
causing passenger(s) to be thrown over-
board. Leading to serious personal injury,
and ste er ing system and /or shif ting
mechanism may be damaged.