Maintenance; Checking The Table Extension - RIDGID R4514 Operator's Manual

ADJUSTMENTS

CHECKING THE TABLE EXTENSION

See Figure 76.
Lock the sliding table extension. The sliding table extension
should not move while locked. If the extension moves:
 Lift the table extension lock lever.
 Find the hex coupling located underneath the saw table.
 Loosen the hex locking nuts.
 Turn the hex coupling counterclockwise.
 Lock the table extension lock. Push and pull on the sliding
table extension.
 Readjust hex coupling if necessary.
 Tighten the hex locking nuts against coupling.
HEX LOCKING
NUTS

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a
hazard or cause product damage.
HEX
COUPLING
Fig. 76
50 − English
TO ADJUST THE HEIGHT OF THE TABLE EXTENSION
See Figure 77.
 Lock table extension lever.
 Loosen the four nuts underneath the sliding table
extension.
 Use a square to make sure the top of the sliding table
extension is the same height as the main table.
 Tighten the four hex nuts. Recheck and readjust if
necessary.
SQUARE
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1 during
product operation. If operation is dusty, also wear
a dust mask.
HEX NUT
TABLE
EXTENSION
Fig. 77