Toyota PZ420 I0291 ME Owner's Manual page 25

π
Transfer private call to hands-free
1 Press the Multi-function button.
The system responds: Call menu. {Say a command}.
2 Say Hands-free Mode.
The system responds: Hands-free mode and transfers the call to the hands-free
system.
ó
Note: Pressing and holding the Send button also transfers the call the hands-free
system.
ó
Note: Some handset devices disconnect the Bluetooth® link to the system when the
call is switched to privacy mode. In this case, the Call menu will not be available. To
switch the call to hands-free, press and hold the Send button.
Send DTMF tones
1 Press the Multi-Function button.
The system responds: Call menu. {Say a command}.
2 Say Enter <digits> to send digits as DTMF tones.
You can also use * and # characters.
ó π
Note: You can send DTMF tones from the handset device's keypad.
Hold a call
Press the Send button to put an active call on hold.
π
Press the Send button again to resume a call on hold.
Call waiting
While in a call, an audible beep signals an incoming call. The Multi-Function button and
mute icon flashes quickly.
Press the Send button to place the active call on hold and answer the waiting call. To
reject a waiting call, press the End button. The Multi-Function button and mute icon stop
flashing when the waiting call is accepted/rejected.
π
Switch between active call and held call
1 Press the Multi-function button.
The system responds: Call menu. {Say a command}.
2 Say Switch Call.
The system responds: Switching active calls.
ó
Note: Pressing the Send button switches between held and active calls.
24 Bluetooth® hands-free system
A