Electrolux EON3000 User Manual page 17

1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
8.3 Oven ceiling
You can remove the grill to clean the oven
ceiling more easily.
WARNING!
Deactivate the appliance before
you remove the grill. Make sure
that the appliance is cold. There is
a risk of burns.
1. Remove the screw which holds the
grill. For the first time, use a screw-
driver.
2. Carefully pull the grill down.
3. Clean the oven ceiling with a soft
cloth with warm water and a cleaning
agent, and let it dry.
4. Install the grill in the opposite se-
quence.
WARNING!
Make sure that the grill is correctly
installed and that it does not fall
down.
2
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
8.4 Oven lamp
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
1. Turn the glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4.
Install the glass cover.
8.5 Cleaning the oven door
The oven door has two glass panels. You
can remove the oven door and the inter-
nal glass panel to clean it.
The oven door can close if you try
to remove the internal glass panel
before you remove the oven door.
ENGLISH 17