Mounting The Cubes - Cambridge SoundWorks MicroWorks MicroWorks Instructions Manual

Mounting The Cubes

To a wall:
To wall-mount the cubes on
structurally strong surfaces
(a wall stud or wood panelling),
screw the No. 10 screws into the
material. Allow their heads to
protrude about / " to fit into the
1
4
keyhole slots on the back of
each cube (as shown below).
The plastic anchors supplied
will be needed to secure the
screws in most wall surfaces. If
so, drill 1 / " holes in the wall,
4
then tap the anchors into the
holes until they are flush with
the wall. Then screw the screws
into the anchors until they
protrude about 1 / "
4.
Be sure to apply the stick-on
rubber feet to the back of the
satellite cubes. This assures an
acoustically secure installation.
12