Cambridge SoundWorks MC630-IW Installation And User Manual

Cambridge SoundWorks MC630-IW Installation And User Manual

High performance in-wall speaker newton series hd

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MC630-IW and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Cambridge SoundWorks MC630-IW

  • Page 3: Table Of Contents

    In-Wall Loudspeaker About This Manual ... 4 Product Contents ... 4 Inspecting for Damage ... 5 System Configuration ... 5 Speaker Placement ... 6 Wiring ... 7 Speaker Mounting ... 8 Painting ... 10 Enclosure Cleaning ...10 In Case of Difficulty ... 11 Specifications ...
  • Page 4: About This Manual

    If you are not comfortable with performing a speaker system installation, we recommend you rely on a qualified home entertainment installer. Contact your dealer or Cambridge SoundWorks for assistance in selecting a suitable installer. Introduction Thanks for choosing a Newton HD Series in-wall speaker. The...
  • Page 5: Inspecting For Damage

    Examine each part carefully for shipping damage. If there is any, do not install or use the speaker. Return the speaker to the merchant where you made the purchase or call Cambridge SoundWorks at 1-800 FOR-HIFI (1-800-367-4434) for assistance. System Configuration...
  • Page 6: Speaker Placement

    Left and right rear speakers in a 7.1 system are typically at 140 degrees. If a single rear speaker is used in a 6.1 system, it should be centered on the rear wall. Front speakers should be as close to the height of the TV monitor as practical.
  • Page 7: Wiring

    They will also accept individual banana plugs. • Use at least AWG #18 speaker cable for short runs (under 15 feet). Use AWG #16 or heavier speaker cable for longer runs. •...
  • Page 8: Speaker Mounting

    1-3/4” away from the stud center. Installing the MC650-iw horizontally as a center- channel speaker will require cutting through at least one wall stud. The MC630-iw may be mounted without cutting through any studs if it is carefully located.
  • Page 9 Maneuver the other side clamp through the hole and center the speaker within the cutout. Tighten the clamp screws firmly using a Phillips head screwdriver.
  • Page 10: Painting

    Distortion dramatically increases the internal operating temperature of a speaker and will eventually cause the speaker’s failure due to burned or melted internal parts. While Cambridge SoundWorks includes the most heat-tolerant parts commensurate with good acoustic design, the speaker’s Limited Warranty against defects in materials or workmanship does...
  • Page 11: In Case Of Difficulty

    Specifications Dimensions: MC650-iw 20 1/2” H x 7 3/4” W x 3 7/8” D MC630-iw 14 3/4” H x 7 3/4” W x 3 7/8” D Weight: MC650-iw 12 pounds each MC630-iw 10 pounds each Impedance: nominal 8 ohms Recommended amplifier power range: 20W – 100W RMS per channel Frequency Range: 80Hz –...
  • Page 12: Dimensions

    Dimensions MC650-iw MC630-iw - 12 -...
  • Page 14 120 Water Street North Andover, MA 01845 (800) FOR-HIFI (1-800-367-4434) www.cambridgesoundworks.com email: info@cambridgesoundworks.com P81-2450...

This manual is also suitable for:

Mc650-iw

Table of Contents

Save PDF