Decal; Figure - Toro 59192 Installation Instructions Manual

Figure 4

1. Socket set extension
6. Hook end of spring through small hole on spring
bracket (Fig. 3).
7. Open and close discharge door to ensure that
spring is not contacting any part of engine. Make
sure discharge tunnel door closes when handle is
released.
POTENTIAL HAZARD
Be sure that spring does not contact gas
tank or any other part of engine.
WHAT CAN HAPPEN
Wear between spring and engine parts may
result in an unsafe operating condition.
HOW TO AVOID THE HAZARD
If spring contacts any part of engine, do not
install bagger kit on mower. If you need
assistance contact an Authorized Toro
Service Dealer before proceeding.
1
2
505
2. Spring bracket
Install Bagging Decal
1. Thoroughly clean flat area of mower deck
behind discharge tunnel with a soap and water
solution.
Note: Deck must be dry before installing

decal.

2. Install decal in area shown in Figure 5. Do not
place bagging decal over model/serial number
decal.
1
Figure 5
1. Decal location
420
3