Location And Use - Doro BM35 Manual

English

Location and Use

The Baby Monitor is intended for indoor use to monitor a baby from a nearby location.
Please remember that a monitor is no substitute for supervision – always ensure you
can reach your baby within a few seconds should the need arise.
The Baby Monitor only transmits sounds to the parent unit when sounds that exceed
the preset level, such as the baby crying, are heard close to the baby unit. (see below).
Place the baby unit near to and with the front facing the child.
Ensure that the baby unit is out of the child's reach; never place the baby unit in the cot
or pram!
To avoid acoustic feedback do not place the baby and parent units too close to each
other.
Advanced versions, e.g. +1, have multiple parent units/handsets and can be used
as walkie talkies (PMR) as well, or to monitor two children simultaneously, see the
instructions that begin on Page 5.
Connection
Parent Unit ( )
1. Remove the battery cover as illustrated and insert the battery with plus/minus as shown.
2. Connect the parent unit's mains adapter to F and the mains wall socket.
3. Press down until a tone is heard and the parent unit is activated.
1
4. Charge until the battery indicator stop signalling.
5. Unplug the mains adapter and the parent unit is ready for use.