Download Print this page

Important Notes For Installation And Operation - Crown GLTS-30 Installation & Operation Manual

Gas power tilt skillets
Hide thumbs Also See for GLTS-30:

Advertisement

S
PECIFICATIONS
Before installing and operating this equipment, be sure everyone involved in its operation is fully trained and aware of
precautions. Accidents and problems can be caused by failure to follow fundamental rules and precautions.
The following symbols, found throughout this manual, alert you to potentially dangerous conditions to the operator,
service personnel, or to the equipment.
DANGER
This symbol warns of immediate hazards that will result in severe injury or death.
WARNING
This symbol refers to a potential hazard or unsafe practice that could result in injury or death.
This symbol refers to a potential hazard or unsafe practice that could result in injury, product
CAUTION
damage, or property damage.
This symbol refers to information that needs special attention or must be fully
NOTICE
understood, even though not dangerous.

IMPORTANT NOTES FOR INSTALLATION AND OPERATION

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
Improper installation, operation, adjustment, alteration, service or maintenance can cause property damage, injury
or death. Read the installation, operating and maintenance instructions thoroughly before installing, operating or
servicing this equipment.
This product is intended for commercial use only. NOT FOR HOUSEHOLD USE.
PURCHASER: Instructions to be followed in the event the operator of this appliance smells gas must be posted
in a prominent location. This information shall be obtained by consulting the local gas supplier.
Keep the appliance area free and clear from combustibles.
DO NOT obstruct the flow of combustion and ventilation air.
Adequate clearances MUST be maintained for servicing and proper operation.
Contact the factory, the factory representative or a local service company to perform maintenance and repairs
should the appliance malfunction. Refer to warranty terms.
Copyright © 2021 by Crown. All rights reserved. Published in the United States of America.
2
PAGE
OF 16
SAFETY PRECAUTIONS
WARNING
WARNING
FOR YOUR SAFETY:
WARNING
NOTICE
NOTICE
This manual should be retained for future reference.
INSTALLATION & OPERATION MANUAL 10100 REV 0 (04/21)
Gas Power Tilt Skillets

Advertisement

loading

This manual is also suitable for:

Glts-40