Table of Contents
Advertisement
GENERAL OPERATING INSTRUCTIONS
CAUTION
This equipment is designed and sold for commercial use only by personnel trained and experienced in
its operation and is not sold for consumer use in and around the home nor for use directly by the general
public in food service locations. For equipment to be used by the general public, please contact the factory.
T h e A P W W y o t t m o d e l s S E H P S E l e c t r i c H o t P l a t e s a r e e q u i p p e d f o r t h e
v o l t a g e i n d i c a t e d o n t h e n a m e p l a t e m o u n t e d o n t h e f r o n t p a n e l . T h i s u n i t i s
designed to operate on alternating current (A.C.), two wire single phase service only.
DO NOT CONNECT TO DIRECT CURRENT (D.C.).
Total Connected Load:
SEHPS:
at 240 Volts, Wattage is 5,200
at 208 Volts, Wattage is 3,900
INSTALLATION
For your protection, we recommend that a qualified electrician install this appliance. The electrician should
be familiar with electrical installations and your local electrical requirements. The external wiring
should be in conduit or an approved type of flexible cable and of suitable size to carry the load. The
supply circuit should be properly fused and equipped with a means of disconnecting as required
by local electrical code. The body of the hot plate should be grounded (Do not ground to a gas
supply pipe). The connections are made in this unit at the pigtail leads located in the junction
box on the back of the unit. To gain access to the pigtail leads remove cover on junction box.
LOCATE THE UNIT
Do not install the unit closer than 1 inch from a side wall and/or closer than 1 inch from a rear wall.
LEVELING UNIT
Level unit by adjusting the (4) feet for accurate and perfect line up with other APW Wyott series units.
CAUTION
DO NOT INSTALL WITHOUT FEET.
CAUTION
USE ONLY FLAT BOTTOM PANS AND POTS! DO NOT USE RAISED BOTTOM UTENSILS
OR BUCKETS! GOOD HEAT TRANSFER DEPENDS UPON GOOD CONTACT BETWEEN
THE ELEMENT AND POT.
NOTE: Using a 12" diameter or larger pan/pot may cause damage to the element or internal wiring. Such
damages are not covered by warranty. Two (2) heating elements are used. For the SEHPS each element
draws 2,600 Watts on 240 Volts and 1,950 Watts on 208 Volts. The right control knob controls the rear
cooking element and the left control knob controls the front cooking element. On "HI" the element delivers
uninterrupted full heat. Between "LO" and "5" any desired amount of heat can be obtained between 6%
and 60% of full heat.
Signal lights are provided above the control knobs to give a visual check if either one or both heating
units are turned on.
1
Advertisement
Table of Contents
