Back Panel - Peachtree preDAC Manual

B C
B Power ON/OFF Switch: Connects and disconnects AC INPUT to the unit when
the power cord is connected between the AC INPUT and a 100-240VAC 50/60Hz
AC outlet.
C AC INPUT & Fuse Holder: For connection to a 100-240VAC 50/60Hz AC outlet
using the included power cord. The fuse can be replaced after turning the
POWER switch OFF and removing the power cord from the AC INPUT. See
the SPECIFICATIONS section for the the specific fuse values required for each
preDAC model. Caution: using an improper fuse value may cause damage to the
unit. Peachtree Audio accepts no responsibility for any damage caused by the use
of improper fuse values.
D IR INPUT: Accepts 3.5mm input from an Infra-Red (IR) repeater/distribution system.
Insert one end of a 3.5mm cable into this port and connect the other end to the output
of the IR repeater/distribution system. This input allows IR commands to control the
unit when the IR window on the front panel is not in "line-of-sight" of the remote control.
This is common when the preDAC is located in an enclosed cabinet or a different room.
Please contact us if you need more technical details regarding the IR protocol. Note:
To enable the rear panel IR input connector and disable the front panel IR receiver,
press the current input button 10 times in succession until the standby LED blinks
3 times. To disable the rear panel IR input connector and enable the front panel IR
receiver, repeat the procedure above until the standby LED blinks 2 times.
E 12V TRIGGER OUTPUT: Enables power on/off control of another product with a
12V trigger input. Insert one end of a 3.5mm cable into this output and connect the
other end to a 12V trigger input of the product to be controlled. Once connected,
both products should power on and off when using the preDAC on/standby button
on the front panel or remote control.
F SERVICE ONLY: This is NOT a USB audio input! Reserved for service use. Note:
This port may also be used to provide 5V DC to power a USB device that draws
up to 5V/500mA (2.5 Watts) of power.
G USB-A INPUT: Accepts digital audio input from compatible mobile devices. Works
with; iPhone 11 Pro and iPad Pro 10.5-inch.
H BALANCED PREAMP OUTPUT: Provides analog audio output to connect to an
external power amplifier. Note: This output is muted when the mute function is
engaged or when headphones are connected to the front panel.

BACK PANEL

D E F G HI J K
O
M N
L
P
Q
9