Panel's Operating Guideline - EAS Electric E300WHF User Manual

For Eco mode, It works with only heat pump.
For Fast mode, it work with both heat pump and E heater under any conidtion.
By controller, use can select Max.75ºC temperature(This is default limitiation, that we can make judgement
inside factory). With heat pump only, max. water out temperature is 68ºC. With both heat pump+ E heater, it
can be read the selected max. temperature.

5.2.2 Panel's operating guideline

1. Switch on/off operation
Switch on: When the unit in off state, if the user presses the
Switch off: When the unit in on state, if the user presses the
2. Checking and setting temperature
Under the main interface, the user can press the
display and flash. The set temperature can be adjusted by pressing the
back to the main interface if 5 seconds without any operation. Or press the
3. Working mode setting
The user can switch the modes between AUTO, ECO, FAST, and MULT by pressing the
4. Time setting
button to enter the time setting, hour and minute will flash，Press the
Press the
corresponding year (the initial value is 2000) setting；then press the
the or button to set the month (the initial value is 00)；Then press the
minute will flash. Press the
hour, the hour will flash, press the
set the minute, and the minute will flash. Press the
V.2
or
or button to set the date (the initial value is 00)； Then press the
/ button to set the hour (the initial value is 00)；Then press the
button, the unit will switch on.
" button, the unit will switch off.
button to see the set temperature, the set temperature will
or
button to exit the temperature setting.
button to set the month, hour will flash, press
and button to set the minute (the initial value is 00). After
46
button and automatically saved. It will
button.
or button to adjust the
button to set the date, and the
button to set the
button to