Introduction Megapulse III is a new generation of pulse induction metal detecting instruments. The pulse induction system is developed to automatically retune, so that changes in the ground mineralization and unwanted metal targets are eliminated.The unit works at great depths and ranges by smooth and stable operation from the control unit in automatic motion mode.
Page 3
DELAY-This knob changes delay in pulse induction signal. Far left position is for Beaches or Very light soil minerals (signal bounces back to control unit fast with small delay). Set switch top center position for standard or general operating conditions. Far right position of knob to work in heavy mineral ground or VERY deep and large targets (allows signal to reach depths and return to unit…also mineral readings are more dissipated).
STANDARD SEARCH (1m x 1m Coil) The loop cable is embedded in PVC tubes and can be assembled for use or dismantled for transportation easily and quickly. The concentrated magnetic field of the coil allows and excellent detection range on relatively small metal objects.
Page 5
. Small objects like bottle caps, pull tabs, pieces of aluminum are rejected . The device can be operated effectively in highly mineralized soil areas, beaches, fresh and salt waters. . High quality components are used and all critical parts of the circuit are designed to align themselves to signal drift due to changing temperatures .
Page 6
2. Attach Antenna Belt Straps (2) to coil and adjust for comfortable level (for 1 Meter coil ) only. 3. Attach battery connector to back of control box for power. 4. To start, all knobs are FIRST set to “0” or off position at farthest left. 5.
Page 7
You should not carry watches, belt buckles or metal plates in your shoes, as they could cause false signals if close to the search coil. Walk normally, and if the terrain allows it, carry the search coil at a lowest possible and constant level operational height over the ground.
Page 8
-The loss of depth during the operation in the Automatic Mode could be due to incorrect tuning of the detector. General Notes Interference In most of the cases interference is due to magnetic disturbances like power lines and may make detection difficult. Heavy current cables nearby could cause severe interference.
Page 9
Country, regarding the use of metal detectors. Be respectful of public and private property, and the laws, which govern the use of metal detectors, and fill all holes after recoveries. Troubleshooting My unit does not maintain its ground balance. Check the battery. In most cases an undercharged battery will cause this to happen.
Page 10
DeepTech determines the product to be defective in materials or workmanship,DeepTech will replace or repair the product to the original purchaser only.
Need help?
Do you have a question about the MEGAPULSE III and is the answer not in the manual?
Questions and answers