Denali MA11729 Manual

For yamaha wolverine

23001 Industrial Blvd, Rogers, MN 55374 / 1-866-527-7637

Thank you for purchasing a DENALI plow mount. You now own a premium, custom

plow mount to allow you to use your plow with your UTV/SxS. Please note the following

instructions and heed all warnings.

 Your UTV/SxS and plow system can cause death or injury. Please use caution

and common sense when operating your unit.

 Read your Plow Operator Manual, your Winch Operator Manual, and all warning

labels before operating your UTV/SxS.

 Operate your UTV/SxS at a walking speed with the blade installed. Do not

exceed 5 mph (8 km/h) even with the blade up.

 Do not operate the UTV/SxS on slopes greater than 10 degrees with the plow

installed.

 Always lower the plow to the down position before leaving your UTV/SxS

unattended.

SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

866.527.7637

www.motoalliance.com

DENALI Plow Mount

MA11729

Yamaha Wolverine

motoinfo@motoalliance.com

Table of Contents

Need help?

Do you have a question about the MA11729 and is the answer not in the manual?

Page 1 DENALI Plow Mount MA11729 Yamaha Wolverine Thank you for purchasing a DENALI plow mount. You now own a premium, custom plow mount to allow you to use your plow with your UTV/SxS. Please note the following instructions and heed all warnings.
Page 2 23001 Industrial Blvd Rogers, MN 55374 866.527.7637 Please verify that all hardware and parts are included in your package. Kit Contents: Part # Description MA11729 Plow Mount Front Support Bracket 3/8’’-16 x 1.00’’ Serrated Flange Bolt Figure 1 866.527.7637 motoinfo@motoalliance.com...
Page 3 23001 Industrial Blvd Rogers, MN 55374 866.527.7637 Yamaha Wolverine Plow Mount Installation 1. Remove the front plastic brush guard shown in Figure 2 and Figure 3. The MA11729 Plow Mount will replace the brush guard while in use. Figure 2 Figure 3 866.527.7637...
Page 4 MotoAlliance MA11729 23001 Industrial Blvd Rogers, MN 55374 866.527.7637 2. Position the Plow Mount (part 1) over the front of the Wolverine’s frame. Insert two of the 3/8’’-16 x 1.00’’ Serrated Flange Bolts (part 3) into the rear supports as shown in Figure 4 and tighten.
Page 5 MotoAlliance MA11729 23001 Industrial Blvd Rogers, MN 55374 866.527.7637 Figure 5 Figure 6 4. Ensure that all hardware is tightened and attach the plow using the quick release pins included with DENALI Plow Kits. 866.527.7637 motoinfo@motoalliance.com...