Table of Contents
Advertisement
Level Radar LCR20
Installation
Measurement in plastic vessels
Figure 10.6
1
Pipe, tubing
2
Ladder
3
Grate, railing
If the outer wall of the vessel is made of a non-conductive material (e. g. GFR), microwaves
can also be reflected by interfering installations outside of the vessel.
Please ensure there are no interfering installations made of a conductive material in the signal
beam (see the beam angle section for information on calculating the beamwidth diameter).
Please contact the manufacturer for further information.
Weather protection cover
For outdoor use, a weather protection cover is recommended.
The weather protection cover can be ordered as an accessory or together with the device
via the ordering option Accessory enclosed.
Figure 10.7
Note
The sensor is not completely covered by the weather protection cover.
26
1
Measurement in a plastic vessel with a metallic, interfering installation outside
of the vessel
Weather protection cover
2
, e. g. with 40 mm (1.5 inch) antenna
3
Advertisement
Table of Contents
