Related Manuals for Clarke JSM180
Summary of Contents for Clarke JSM180
- Page 1 JUMPSTARTER & DEVICE CHARGER MODEL NO: JSM180 PART NO: 6238900 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0721 REV 2...
-
Page 2: Environmental Recycling Policy
INTRODUCTION Thank you for purchasing this CLARKE Power Pack & Jump Starter Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. - Page 3 CONTENTS AND OVERVIEW 1 Jump Starter Power Pack 3 - 1 USB Charging Cable, Lightning/Micro USB/C-Type 2 12V Battery Jump Starter Lead OVERVIEW Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 4: General Safety Rules
5. DO NOT operate the jump starter if any of the cables are damaged. Consult your CLARKE dealer for repair or replacement of the parts. 6. DO NOT operate the jump starter if the case is damaged. Consult your CLARKE dealer or a qualified person for inspection and repair. -
Page 5: Power Pack Charging
POWER PACK CHARGING 1. Fully charge your jump starter battery unit before using it for the first time. 2. Recharge the jump starter battery unit after every occasion of use if possible, and thereafter, at least every 6 months. 3. ALWAYS AVOID leaving your jump starter unit in a discharged state. FOLLOW THE ABOVE POINTS TO ENSURE MAXIMUM LIFE FROM THE BATTERY. -
Page 6: Maintenance
DO NOT use solvents as a cleaning agent. NEVER attempt any repair unless your are a qualified technician. Your CLARKE jump starter has been designed to give long and trouble free service. If, however, having followed the instructions in this booklet carefully, you encounter problems, take the unit to your local CLARKE dealer. -
Page 7: Operation
OPERATION WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE SAFETY INSTRUCTIONS ON PAGE 6 MAY RESULT IN PERSONAL INJURY, DAMAGE TO THE VEHICLE, OR THE POSSIBILITY OF AN EXPLOSION LED LIGHT The power pack has an LED light that has 3 settings and can be used as a torch or safety lighting as follows. - Page 8 • Ensure the vehicle battery is rated at 12V and is not damaged in any way. If the battery is damaged, replace battery, DO NOT try and recharge. • Ensure the battery terminals are clean and the clamps are firm and secure.
-
Page 9: Specifications
SPECIFICATIONS Item Specification Model No. JSM180 Max Engine Capacity Under 3.0L (Petrol Only) Battery Type Lithium Ion Polymer (Li-Po) Battery Capacity 1800 mAh Input (C-type cable) 5V/1A Output for Mobile Devices (USB) 5V/1A Output for Car Jump Start Current Start/Peak... -
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 11 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 12 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the JSM180 and is the answer not in the manual?
Questions and answers