Setting Up The Printer For Apple Macintosh Computers; (For Hl-730/730Plus Series Only); Paper Handling - Brother HL-700 Series User Manual

Brother user's guide laser printer hl-700 series
Hide thumbs Also See for HL-700 Series:
Table of Contents

Advertisement

USER'S GUIDE
Setting Up the Printer for Apple Macintosh Computers When the
Optional RS-100M Serial Interface Is Installed into Your Printer

(For HL-730/730Plus series Only)

Question
I cannot print from my
application software.

Paper Handling

Question
The printer does not load paper.
The printer does not load paper
from the manual feed slot.
How can I load envelopes?
What paper can I use?
How can I clear paper jams?
CHAPTER 6 –10
Recommendation
Make sure that the supplied Macintosh printer
driver is installed in the System Folder and it is
selected with Chooser.
Check the PORT selection within the Chooser: it
should match the port to which you physically
attached the printer cable.
The serial slide switch of the optional interface
board should be in the Apple (RS-422A) position.
Check the printer cable type: you cannot use a
LocalTalk or straight-through cable. Refer to
Chapter 4
for details on printer cable type.
Recommendation
Check to see if the "Paper Empty" message appears
on your computer screen or the Alarm and Paper
lamps are blinking on the printer control panel. If
so, the multi-purpose sheet feeder may be out of
paper or not properly installed. If it is empty, load a
new stack of paper into the feeder.
If there is paper in the multi-purpose sheet feeder,
make sure it is straight. If the paper is curled, you
should straighten it before printing. Sometimes it is
helpful to remove the paper, turn the stack over and
put it back into the paper tray.
Reduce the amount of paper in the multi-purpose
sheet feeder, then try again.
Re-insert the paper firmly, one sheet at a time.
You can load envelopes from either the multi-purpose
sheet feeder or the manual feed slot. Your application
software must be set up correctly to print on the
envelope size you are using. This is usually done in the
page setup or document setup menu of your software.
Refer to your application manual.
You can use plain paper, envelopes, transparencies,
labels, and organizer paper. For information on loading
paper, see
"Paper Handling"
See
"PAPER JAMS"
in this chapter.
in Chapter 2.

Advertisement

Table of Contents
loading

Table of Contents