Garland XTRIM 900 G Instruction Manual page 35

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
machine make sure the engine is off and remove the
spark plug cap.
WARNING! Do not modify the machine or change
the cutting elements. An inadequate use of these
elements can cause serious personal damages and
can even be fatal.
Never try adjustments in the machine if it is running
and / or attache to the user by the harness. Perform
all maintenance of the machine when is set on a flat
and clear surface.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Carburetor adjustment is complicated and should
be done only by the service.Carburetor regulation
is complicated and should only be carried out by a
service agent. An incorrect regulation of the carburetor
can cause damages to the engine and is sufficient
motive to cancel the warranty.
The removal of security devices, an improper
maintenance, the substitution of elements with non
original elements can cause corporal damages.
8.1. MANTENIMIENTO PERIÓDICO
Make periodic inspections of the machine to
ensure that the machine is correct. For a thorough
inspection take the machine to your dealer.
Carry out maintenance work based on the following
table:
Operation
Each 2
petrol
deposits
Air filter
Petrol filter
Spark plug
Cylinder fins
8.1.1. AIR FILTRE
- The dirt in air filter will cause a reduction in
machine performance. Check and clean this
element. If you notice damage or alterations
replace it with a new filter.
To clean the filter:
1. Remove the protecting cover.
2. Remove the filter.
3. The dust accumulated on the outside of the filter
can be removed using your hands or against a
hard object.
4. Clean the filter with soapy water.
5. Rinse the filter with abundant water.
6. Allow the filter to dry.
7. Once dry, place two drops of oil (do not put too
much oil as otherwise the machine will not start).
8. Reinstall the air filter.
9. Replace the protecting cover.
Note: The engine should never started without the air
filter being in place.
8.1.2. FUEL FILTRE
The fuel tank is equipped with a filter. It is at the end
of the suction pipe and can be removed with the help
of a hook of wire.
35/104
English
Each 10 petrol
Once a
deposits
year

Advertisement

Table of Contents
loading

Table of Contents