Kernau KFD 9603 User Manual page 41

WARNING:
In the appliance enclosure or in the built-in structure, keep ventilation
openings clear of obstruction.
• Before contacting the local Authorised Service Provider for the installation of the
dryer, check the information in the user manual to make sure that the electrical
installation and water outlet is suitable. If they are not, call a qualified electrician
and a plumber to have the necessary adjustments made.
• It is the customer's responsibility to prepare the dryer's installation place, as well
as the electricity and waste water installation. Before installation, check the dryer
for damage. If damaged, do not have it installed. Damaged products may endanger
your health.
• Install the dryer on a stable and flat surface.
• Run the dryer in a dust-free environment where the air ventilation is good.
• The clearance between the dryer and the floor should not be reduced with objects
such as carpets, wood or tape.
• Do not block the ventilation grills found on the plinth of the tumble dryer.
• The appliance must not be installed behind a lockable door, a sliding door or a door
with a hinge on the opposite side of the tumble dryer, in such a way that blocks the
full opening of the tumble dryer door.
• Once the dryer has been installed, the connections must remain stable. When
installing the dryer, make sure that the rear surface is not leaning on anything (e.g.
tap, socket).
• The operating temperature of the dryer is +5°C to +35°C. If operated out of this
temperature range, the performance of the dryer will be affected negatively and the
product will be damaged.
• Be careful when carrying the product since it is heavy. Always wear safety gloves.
• Always install the product should be placed against a wall.
• The rear surface of the product should be placed against the wall.
• When the product is placed on a stable surface, use a water level to check if it
is fully stable. If not, adjust the feet until it becomes steady. Repeat this process
every time you relocate the product.
• Do not place the dryer onto the power cable.
EN 41