Parallax 32440 Manual page 6

Arduino Uno
// Requires remote XBee in loopback mode (DIN connected to DOUT)
#include <SoftwareSerial.h>
#define Rx 6
#define Tx 7
SoftwareSerial Xbee (Rx, Tx);
void setup() {
Serial.begin(9600);
Xbee.begin(9600);
delay(500);
}
void loop() {
if(Serial.available()) {
char outgoing = Serial.read();
Xbee.print(outgoing);
}
if(Xbee.available()) {
char incoming = Xbee.read();
Serial.println(incoming);
}
delay(50);
}
Copyright © Parallax Inc.
// DOUT to pin 6
// DIN to pin 7
// Set to No line ending;
// type a char, then hit enter
// Is serial data available?
// Read character, send to XBee
// Is data available from XBee?
// Read character,
// send to Serial Monitor
Page 6 of 7