Monogram ZWE23E Installation Instructions Manual page 10

STEP 4
REMOVE THE REFRIGERATOR
DOORS (CONT)
C. Disconnect both electrical connectors at the top
cover.
Remove the 1/4" hex head screw to disconnect the
ground wire from the hinge.
Remove the 1/4" hex head screw to remove the
strain relief from the water line.
Ground
screw
D. Disconnect the water line from the back of the unit
by pressing down on the dark grey collar while
pulling up on the water line.
Pull waterline through case conduit from the top to
free the line for door removal. The water line is more
than 4' long and may need to be taped to Door for
accessibility when reinstalling.
E. Using a 8mm socket ratchet/driver, remove the
screws securing the top hinge to the cabinet, then lift
the hinge straight up to free the hinge pin from the
location in the top of the door.
Screws
10
Installation Instructions
Strain
Relief
STEP 4
REMOVE THE REFRIGERATOR
DOORS (CONT)
CAUTION
Lifting Hazard.
Single person lift could cause injury. Use assis-
tance when handling, moving or lifting the refriger-
ator doors.
Avertissement de porte
ATTENTION
lourde.
Le soulèvement de la porte par une seule personne peut
présenter un risque de blessure. Obtenir de l'assistance
lors de la manipulation, du déplacement ou du soulève-
ment des portes du réfrigérateur.
Riesgo al levantar
PRECAUCIÓN
la puerta
Si es levantada por una sola persona, podrían ocasio-
narse lesiones. Solicite ayuda al sostener, mover o
levantar las puertas del refrigerador.
NOTE: when removing door, to prevent damage to
door and electronics, carefully place the door in a
proper location.
NOTE: The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self
close properly. Please follow the directions carefully.
NOTE: for proper installation later, please follow
the next step carefully.
F. Refrigerator doors to be REMOVED and
INSTALLED opened at 90° with case front.
REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite door.
There are no wires or water lines on the opposite
side.
G. REMOVE CENTER HINGE (if necessary)
Remove the inner, larger 8mm hex head screws
securing the center hinge to the cabinet. Use the
T25 Torx / 1/4" Hex / PSD#2 driver to remove
outboard screw.
Remove
center screw
Loosen Outer screws
31-1000602 Rev. 0