Table of Contents
Advertisement
Vibra-Call function
Midland G7/G7E Pro is equipped with the "Vibra-Call" feature, which provides
a vibration for incoming calls.
To activate it, follow these steps:
20
20
1.
In the PMR band, press the MENU button for 10 times, until the display
shows
;
PMR
2. Use the
/
buttons to disable or enable this feature (on: enables,
oF:disables);
3. Push PTT to confirm or wait for 10 seconds.
21
21
Everytime Midland G7/G7E Pro receives a call, it will vibrate.
22
22
When the Vibracall function is enabled, the call tone won't be heard.
23
23
24
24
ROGER BEEP (End transmission tone)
15
15
Every time you end transmission (PTT released), Midland G7/G7E Pro gives
out a sound that indicates to the other party that s/he can start talking. This
function is factory disabled.
To activate it:
1.
Press six times the MENU button in the PMR band until the display shows
"rb oF";
2. Using the scroll buttons / select "on" and "rb on" will be displayed;
3. To confirm the roger beep activation, press PTT button or wait for 10 se-
conds.
CALL function
Midland G7/G7E Pro can send 5 different call tones. To send this audio signal
to other users, press the CALL/ key.
To select the call tones:
1.
Push the MENU button 7 times in the PMR band, until the display shows
"CA 1".
2. By pushing / you will hear the 10 pre-set melodies.
3. Confirm by pressing the PTT key or wait for 10 seconds.
Now, each time your Midland G7/G7E Pro sends out a tone call, it will beep
with the selected melody.
If the Vibracall function is activated (See par. "Vibra-call function"), the call
tone won't be heard.
18 |
Midland G7 Pro user's manual
Dual Watch function
This function allows the monitoring of 2 channels of your choice.
Procedure:
1.
Select one of the 2 channels you want to monitor.
2. Press 9 times the MENU button in the PMR band until the display shows
"TX oF RX".
3. With the / button select the second channel to monitor.
4. Push the PTT key or wait for 10 seconds for confirmation.
To disable the function, press the MON/SCAN button.
Keypad beep
To deactivate the keypad beep, follow these steps:
1.
Press for 8 times the MENU button in the PMR band, until "bP on" is
displayed.
2. Use the / buttons until the display shows "bP of".
3. Confirm by pushing the PTT or wait for 10 seconds.
Now you won't hear any beep at the pressure of any button.
Troubleshooting and radio reset
Your Midland G7/G7E Pro is designed to provide you with years of optimal
performance. If for some reason problems arise, refer to this chapter before
contacting a service centre in your region.
Reset
If your transceiver experiences a logical malfunction (improper symbols on the
display, blocking of functions, etc.), it may not be experiencing a true failure,
but rather a problem caused by external factors. For example, it may have an
incorrect setting brought on by a noise or spikes in the electrical system during
battery recharging. In such cases, you can reset the transceiver to its factory-
programmed settings, by resetting all parameters:
1.
Turn off the transceiver
2. Keep pressed the
button and turn on the radio at the same time. All the
functions will be reset ex-factory.
Before you go ahead with the reset, we recommend that you take note of all
the setting you have carried out as they will be deleted.
Midland G7 Pro user's manual
| 19
Hide quick links:
Advertisement
Table of Contents
