Safety Measures - BEHA UNITEST 93408 Instruction Manual

Conformity symbol, confirms respect of valid EMV Directive (89/336/EEC). Standards
EN 50081-1 and EN 50082-1 are respected.

2.0 Safety Measures

Remove sensor cover only shortly before measuring and always replace it immediately upon
completion of measurement.
In order to prevent accidents at work, please note the following:
Tubular fluorescent lamps can create a stroboscopic effect by means of which the per-
ceived movement of objects is subject to optical illusion (e.g. in case of quickly rota-
ting jaw chucks of lathes).
Increases in the illumination are only registered as from a factor of 1.5.
Illumination of working areas must not fall below factor 0.8 of the nominal
illumination.
At no time must the illumination of working areas fall below factor 0.6 of the nominal
illumination.
Highly varying degrees of brightness strain the human eye very quickly (this causes
adaption difficulties).
Glare impairs a person's sight and health.
The ageing of light sources is a factor which must be taken into consideration.
Safety Measures
15