Setting Up The Appliance - iGenix IG2070 User Manual

SETTING UP THE APPLIANCE

1. Make sure that all the packing materials are removed from the inside of the
door.
WARNING: Check the oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surface, broken or loose door hinges and latches
and dents inside the cavity or on the door. If there is any damage, do not operate
the oven and contact our Customer Service Dept.
2. This microwave oven must be placed on a flat, stable surface to hold its
weight and the heaviest food likely to be cooked in the oven.
3. Do not place the oven where heat, moisture, or high humidity are generated,
or near combustible materials.
4. For correct operation, the oven must have sufficient airflow. Allow 20cm
of space above the oven and a minimum of 10cm between all sides and any
adjacent walls. Do not cover or block any openings / vents on the appliance.
5. Do not remove feet.
6. Do not operate the oven without glass tray, turntable ring, and shaft in their
proper positions. Never place the glass tray upside down. A cracked glass tray
or turntable ring must be replaced before use.
7. Place the oven as far away as possible from radios and TV's as it can cause
interference.
8. Make sure that the power supply cord is undamaged and does not run under
the oven or over any hot or sharp surface.
9. Plug the oven into a standard household power outlet. Ensure that the
voltage and frequency of the outlet is the same as the oven.
10. The socket must be readily accessible so that it can be easily unplugged in an
emergency.
WARNING: Do not install the oven over a range cooker top or other heat
producing appliance. If installed near or over a heat source the oven could be
damaged and the warranty will be void.
8