Fcc Compliance Statement - Bushnell ONIX200 Quick Start Manual

FCC Compliance Statement

The ONIX complies with Part 15 of the FCC interference limits for Class B digital
devices FOR HOME OR OFFICE USE. These limits are designed to provide
reasonable protection against harmful interference in a residential installation, and are
more stringent than "outdoor" requirements.
Operation of this device is subject to the following conditions; (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV
technician for help.
The ONIX does not contain any user-serviceable parts. Repairs should only be made
by an Authorized Bushnell repair center. Unauthorized repairs or modifications could
result in permanent damage to the equipment, and will void your warranty and your
authority to operate this device under Part 15 regulations.
The shielded interface cable which is provided must be used with the equipment in
order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.

Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.