Advertisement
6. Programming another transmitter
1. The receiver can be controlled by a maximum of 20 transmitters.
2. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
Press
programming button P2
on the A remote control.
7. Deleting all transmitters
Press
programming button P2.
8. Activating impulse mode
1. When impulse mode is activated, single push of UP or DOWN button forces motor to make single part of a full turn, and
when UP or DOWN button is being held for 2 seconds it will force motor to run constantly.
2. To reverse this procedure please repeat the instruction.
Press
programming button P2
will make a sound.
on the remote control.
9. Programming key-ring remotes
1. When programming key-ring remotes that do not have additional P2 programming button the same function is substituted
with simultaneous push of STOP and UP buttons.
2. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this method will result in deleting receiver memory.
Turn on power supply
Control unit
or press programming
will make a sound.
button when
power is on.
Control unit will
make a sound.
programming button P2
on the A remote control.
Control unit
will make a sound.
Control unit
Press
UP button.
Control unit
Press simultaneously
STOP and UP
will make a sound.
programming buttons.
Press
Control unit will
make a sound.
programming button P2
on the B remote control.
Press
Control unit
STOP button.
will make a sound.
Control unit
Press
will make a sound.
programming button P2
on the remote control.
Control unit
Press simultaneously
STOP and UP
will make a sound.
programming buttons.
3
Press
Control unit
will make
a few sounds.
Press
Control unit
programming
will make
button P2.
a few sounds.
impulse mode single push of
a button on the remote will
Control unit will
make a few sounds.
Press
Control unit
UP button.
will make a few
sounds.
Remote control
has been programmed.
All remotes
have been removed.
When motor is in
cause motor to make
short move.
Key-ring remote has
been programmed.
Advertisement
