Advertisement
ILLUMINATING INDICATORS
Low Battery Charge (
) When the low battery
symbol is displayed in the upper right-hand portion of the LCD, the battery charge is
getting low and the 9-volt alkaline battery should be replaced.
Target Acquired: Informs the user that a distance measurement has been obtained.
The message "TARGET ACQUIRED" will appear in the top portion of the LCD. The
distance measured will appear at the bottom of the LCD in numerical form.
SPECIFICATIONS
OPTICAL DESIGN The CLR 800 features a Perma Focus monocular optical system
for viewing your target. A liquid crystal display (LCD) is mounted within the optical
system and when activated, displays a reticle for targeting, yards, and low battery
indicators. Inherent in the manufacturing process are small black spots that appear
in the optical system. These are a natural characteristic of the LCD and cannot be
fully eliminated in the manufacturing process. They do not affect the distancing
performance of the unit.
Dimensions: Pocket Size, measuring 1.9 x 4.1 x 4.2 inches
Weight: 8 oz.
Accuracy: +/- 1 yard
Magnification: 5x
Display: LCD (even and odd numbers)
Power Source: 9 volt alkaline battery (user supplied)
FOV: 341 ft. @ 1000 yards
Total Eye Relief: 19mm
Exit Pupil: 4 mm
Single Button Operation
Water resistant
5-yard minimum, 800 yards to a reflective target, 600 yards to a tree, 300 yards to a deer
Includes case and strap
CLEANING
We suggest using the Cabela's lens pen as an effective tool for keeping your
CLR 800 in top condition. However, you may also gently blow away any dust or debris
on the lenses (or use a soft lens brush). To remove dirt or fingerprints, clean with a
soft cotton cloth, rubbing in a circular motion. Use of a coarse cloth or unnecessary
rubbing may scratch the lens surface and eventually cause permanent damage. For
a more thorough cleaning, photographic lens tissue and photographic-type lens
cleaning fluid or isopropyl alcohol may be used. Always apply the fluid to the
cleaning cloth - never directly on the lens.
TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
• Depress power button.
• Check and if necessary, replace battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality
alkaline battery. Heavy Duty alkaline batteries are NOT recommended.
There is no reset button to clear last range reading before ranging another target:
• The last range reading does not need to be cleared before ranging another target.
Simply aim at the new target using the LCD's reticle, depress the power button and
hold until new range reading is displayed.
If target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the power button is being depressed
• Make sure that nothing, such as your hand or finger, is blocking the objective
lenses (lenses closest to the target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
Advertisement
