Cleaning - Bunn SmartWave APS Installation And Operating Manual

CLEANING

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
CLEANING OPTIONAL LARGE SPRAYHEAD
1. Remove the brew funnel.
2. Remove the sprayhead by turning it counterclockwise with your fi ngertips.
3. Disassemble sprayhead by removing rubber gasket.
4. Check the holes in the sprayhead. If plugged by lime, they may be cleared using a toothpick. Rinse the
sprayhead with water.
5. Reassemble the sprayhead according to FIG 11. NOTE: Verify the indents are aligned. (ARROWS)
6. Reinstall the sprayhead by turning it clockwise. Hand tighten only!
FIG 12
FIG 11
Page 13 40410 092407