General Safety; Blade Safety - Toro Greensmaster TriFlex 3300 Series Operator's Manual

Safety

General Safety

This product is capable of amputating hands and feet.
Always follow all safety instructions to avoid serious
personal injury.
•
Read and understand the contents of this
Operator's Manual before starting the engine.
•
Do not put your hands or feet near moving
components of the machine.
•
Do not operate the machine without all guards
and other safety protective devices in place and
working on the machine.
•
Keep clear of any discharge opening. Keep
bystanders and pets away from the machine.
•
Keep children out of the operating area. Never
allow children to operate the machine.
•
Park the machine on a level surface, lower the
cutting units, disengage the drives, engage the
parking brake (if provided), shut off the engine,
and remove the key before leaving the operator's
position for any reason.
Improperly using or maintaining this machine can
result in injury. To reduce the potential for injury,
comply with these safety instructions and always
pay attention to the safety-alert symbol
means Caution, Warning, or Danger—personal safety
instruction. Failure to comply with these instructions
may result in personal injury or death.
Spiker Safety
•
The spiker is only a part of a complete machine
when installed on a traction unit. Read the traction
unit Operator's Manual carefully for complete
instructions on the safe use of the machine.
•
Stop the machine, remove the key, and wait for
all moving parts to stop before inspecting the
attachment after striking an object or if there is
an abnormal vibration in the machine. Make all
necessary repairs before resuming operation.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Use only accessories, attachments, and
replacement parts approved by Toro.

Blade Safety

A worn or damaged spiker blade can break, and a
piece of it could be thrown toward you or bystanders,
resulting in serious personal injury or death.
•
Inspect the spiker periodically for wear or damage.
•
Use care and wear gloves when checking or
servicing the spiker.
•
On machines with multiple cutting units, take care
as rotating 1 spiker can cause other spikers to
rotate.
, which
3