Advertisement
Timers
Timed OUT Indicator
Digital Time Display
(LCD backlit with red LED)
j Indication Mode Selector
Step 1
Desired Mode of Operation
Operation Mode
ON-Delay One-Shot
Select the
time display and
Cycle One-Shot
operation modes.
ON-Delay One-Shot 2
Step 2
Desired Mode of Operation
Desired Single-Shot
Select the
single shot output
time.
Step 3
0.01 seconds to 9.99 seconds
Select a time range
0.1 seconds to 99.9 seconds
that contains the
1 second to 999 seconds
desired period of time.
0.1 minutes to 99.9 minutes
1 minute to 999 minutes
0.1 hours to 99.9 hours
Step 4
Set the precise period of time desired by using the m Time Setting Digital Switch.
It is important to remember that the l Time Range Selector not only selects the time range but also infl uences the interpretation of the Digital Time Display.
Changing the l Time Range Selector setting changes the units of time measurement (seconds, minutes, hours) as well as the decimal point location.
For information, call 800-221-0487
Instructions: Setting GT3D-8 Timers
1
1
Time Display Mode
j Indicator Mode Selector
Time elapsed
Time remaining
Time elapsed
Time remaining
Time elapsed
Time remaining
Output Time
0.1 seconds
0.5 seconds
1 second
5 seconds
10 seconds
50 seconds
Desired Operation
Base Time Ranges
Decimal Point
Indicator
Desired Operation
Switches Unlimited
USA: 800-262-IDEC
tech@switchesunlimited.com
k Operation Mode Selector
A, B, C, D, E, F
Selection
1
1. Use a fl at screwdriver to set the selectors. Since selectors do
1
not turn all the way around, both clockwise and counterclockwise
rotation is necessary.
2
2. The GT3D-8 j Indicator Mode Selector selects both whether the
Digital Time Display displays the time elapsed or time remaining
2
and also the mode of operation. Decide which display and mode is
desired. Then use this selector to set the operation mode.
3
3
Selection
k Single-Shot Output
Time Selector
A
On the GT3D-8 timers, the desired single-shot output time can be
B
selected from the A, B, C, D, E, and F modes using the k One-Shot
C
Output Time Selector.
D
E
F
Selection
l Time Range Selector
1. The l Time Range Selector controls both the decimal point indi-
Time Increment
cator (9.99, 99.9, 999) and the time increment indicators S (seconds),
Indicator
M (minutes), and H (hours).
9.99
2. Chose which base time range contains the targeted timer setting.
S
99.9
Then use the l Time Range Selector to set the decimal point indica-
tor and time increment indicator to its corresponding pair of settings.
999
3. Since these confi gurations offer a complete range of settings
99.9
from 0.01 seconds to 99.9 hours, the setting of 9.99 for minutes and
M
the 9.99 and 999 settings for hours are not listed and should not be
999
used.
H
99.9
Selection
Use the m Time Setting Digital Switch to set the desired period of
time. It is important to remember that the setting of the l Time
Range Selector determines the units of time measurement as well
as the implied decimal point location.
Fax 718-672-6370
Canada: 888-317-IDEC
sales@switchesunlimited.com
GT3D Series
m Time Setting
Digital Switch
l Time Range Selector
9.99S – 99.9H
Remarks
Remarks
Remarks
Remarks
www.switchesunlimited.com
825
Advertisement
