Rinse/Run Switch; P2635; Location; 1. Disconnect The Dispenser From The Power - Bunn FMD-4 Operating & Service Manual

SERVICE (cont.)

RINSE/RUN SWITCH

FIG. 25 RINSE/RUN SWITCH

Location:

The rinse/run switch is located on the lower center
of the whipper motor mounting panel.
Test Procedures:
1. Disconnect the dispenser from the power

source.

2. Check for continuity between the center left
terminal and left bottom terminal, also between
the center right terminal and the right bottom
terminal with the switch in the rinse position (up-
per). Check for continuity across the center left
terminal and the top left terminal, also between
center right terminal and the top right terminal
with the switch in the run position (lower). Con-
tinuity must not be present when the switch is
in the center position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Open the dispenser door.
2. Remove the facenut securing the run/rinse switch
to the whipper motor mounting panel.
3. Remove switch with wires attached from the back
side of the whipper motor mounting panel.
4. Disconnect the wires from the switch and discard
the switch.
5. Refer to Fig. 26 when connecting the wires to the
new switch.
6. Install new switch with wires attached through
the hole in the whipper motor mounting panel
and secure with facenut.
BRN/BLK to
Main Harness

P2635

BLK from
Main Harness
BRN/BLK to
Main Harness
FIG. 26 RINSE/RUN SWITCH TERMINALS
32
GRY to Control
Board J2-2
GRN to Control
Board J2-9
WHI/GRY to Control
Board J2-3
P1644
35135 012103