Lamp Holder - Bunn FMD DBC-3 Operating & Service Manual

SERVICE (cont.)
HOT/COLD SWITCH (Optional) (cont.)
If continuity is present as described, the hot/cold
switch is operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Remove all wires from the switch terminals.
2. Remove the mounting nut on the front of the whip-
per motor mounting panel.
3. Remove the hot/cold switch from the rear of the
front panel and discard.
4. Reconnect the wires to the terminals on the rear
of the new switch.
5. Push new hot/cold switch through the hole on the
left side of the whipper motor mounting panel and
secure with mounting nut.
6. Refer to Fig. 21 when reconnecting the wires.
TAN to Main Harness
RED to Main Harness
WHI/YEL to Cold So-
lenoid
FIG. 21 HOT/COLD SWITCH TERMINALS

LAMP HOLDER

1
5
2
6
1. Door Assy
P1208
2. Lamp Holders
3. Lamp
Location:
The lamp holders are located on the front of
the upper panel behind the display panel.
Test Procedure:
1. Disconnect the dispenser from the power source.
2. Remove upper door panel (4) and disconnect the
door wiring harness from the leads on the lamp
holders.
3. Remove lamp from lamp holders.
4. Check for continuity on each lead of the lamp
holders.
If continuity is present as described, lamp holders are
operating properly.
If continuity is not present as described replace the
lamp holder.
31
FIG. 22 LAMP HOLDERS
4. Upper Panel
5. Lower Panel
6. Starter W/Socket
3
4
P1454.70
29215 101599