Midi Program Numbers Programming; Preset's Copying; Bank Copying; Cc Controllers' Value Programming - G-Lab GSC-2 User Manual

Guitar system controller
Hide thumbs Also See for GSC-2:
Table of Contents

Advertisement

MIDI program numbers programming

The controller enables to control three MIDI devices (MIDI 1, MIDI 2 and MIDI 3) by the Program Change
command. Before programming, the MIDI channels should be set (see: MIDI channel setting).
a) Connect MIDI cable between MIDI OUT output connector and MIDI IN input connector of the
controlled device.
b) Select bank and preset.
c) Memory access lock switch to UNLOCK position (LOCK indicator not lit).
d) Press MIDI 1 button (MIDI 1 indicator will start to blink). Actual program No. or text unused (what
means that command is not send) will appear on display.
e) Enter program No. using footswitches (e.g. for program No. 24 press footswitch No. 2 and then
footswitch No. 4). If you don't want to send Program Change command in this preset press
footswitch No. 0 and hold for minimum 1 second (text unu will appear on display).
Available program numbers are from 1 to 128 (transmitted values from 0 to 127). The text Err
means the number is out of the range.
f) Press MIDI 1 button to save. Displaying text Stored confirms saving.
In case of necessity of escape without saving while the point e) it should be pressed LOOP or SWITCH
button.
For MIDI 2 device do it in similar way and for MIDI 3 device the MIDI 1 and MIDI 2 buttons should be pressed
simultaneously. The MIDI 3 program number can be programmed in this way only when the setting at LOOP
button (No. 6 footswitch) is set to n3p (MIDI 3, only Program Change command).

Preset's copying

a) Select preset to copy.
b) Memory access lock switch to UNLOCK position (LOCK indicator not lit).
c) Press at simultaneously LOOP and MIDI 2 buttons (LOOP and MIDI 2 indicators start to blink and
SWITCH and MIDI 1 indicators start to lit).
d) Switch bank (if necessary) and choose preset No. where to past copied preset.
e) Press simultaneously LOOP and MIDI 2 buttons to save preset. Text Stored confirms saving.
In case of necessity of escaping without saving while in the point d) should be pressed SWITCH or MIDI 1
button.

Bank copying

a) Select any preset of the bank to copy.
b) Memory access lock switch to UNLOCK position (LOCK indicator not lit).
c) Press simultaneously SWITCH and MIDI 1 buttons (SWITCH and MIDI 1 indicators start to blink
and LOOP and MIDI 2 indicators start to lit).
d) Choose a bank where to past copied bank.
e) Press simultaneously SWITCH and MIDI 1 buttons to save bank. Text Stored confirms saving.
In case of necessity of escaping without saving while in the point d) should be pressed LOOP or MIDI 2
button.

CC controllers' value programming

The GSC enables to control MIDI 3 device by Control Change commands. Before value programming at
LOOP button settings (footswitch No. 6) set transmitting Control Change commands (m3c), and set
controllers' numbers (see: Controllers' numbers setting for Control Change commands).
a) Select bank and preset.
b) Memory access lock switch to UNLOCK position (LOCK indicator not lit).
c) Press simultaneously MIDI 1 and MIDI 2 buttons (MIDI 1 and MIDI 2 indicators start to blink). The
text ctl will appear on display.
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSC-2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Gsc-3

Table of Contents