Advertisement
4.
Connect the RJ-45 plug into the Ethernet
connector, then screw the waterproof
connector to the Ethernet connector by
turning it clockwise about one half-turn.
Figure 15: Attaching the Waterproof Connector
5.
Screw the back part of the waterproof
connector clockwise until there is a tight
seal around the Ethernet cable.
Figure 16: Tightening the Connector
6
6.
T h e p o we r c o n n e c t o r a n d re s e t
button cables are not waterproof. It is
recommended to use waterproof tape
to protect them. Wind the tape around
each cable in an overlapping manner to
cover them.
Figure 17: Wrapping the Power
Connector and Reset Button
Quick Installation Guide
Advertisement
