Advertisement
5.
Reattach the lining to the camera body
by sliding it on until it clicks. Replace
the dome cover and refasten the screws
securing it in place.
Figure 10: Replace the dome cover
Adjusting the Lens
The angle, zoom and focus of the lens can
adjusted using the web UI. For information on
how to do this, refer to the User Manual.
Figure 11: Positioning the Lens
Quick Installation Guide
Waterproofing Your Installation
To waterproof your camera, follow the instructions
below. A round Ethernet cable, a crimping tool,
and RJ-45 plugs are required for this procedure.
1.
Place the washer around the base of the
Ethernet connector as shown.
Figure 12: Attaching the Washer Ring
2.
Thread the bare Ethernet cable through
the waterproof connector as shown.
Figure 13: Threading the Cable
3.
Attach an RJ-45 plug to the end of the
cable using a crimping tool.
Figure 14: Attaching the RJ-45 Connector
5
Advertisement
