Advertisement
Lumination
RC/LRC/RXLRX Series
®
Note: Applicable only to 10in and 12 in Fixtures
21
Affix the hook of the safety tether onto the bracket of
the frame kit.
23
Load springs into an upright position by twisting
the springs upward a. Carefully insert the fixture
into the hole of the rough-in frame. Verify that
the reflector trim is flush to the ceiling.
www.gecurrent.com
© 2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
IND259 (Rev 12/18/20) A-1028951
22
Connect the two quick connectors and reas-
semble the connector box.
24
Once installed, LRX Gimbal downlight's light
engine can be rotated up to 359° horizontally
and tilted up to 35° vertically.
Note: it is recommended to use gloves while
handling and adjusting the Gimbal light engine
to prevent dirt and oils from contaminating the
surface of the luminaire.
Installation Guide
Advertisement
