MODSTER EASY 800 TRAINER User Manual page 30

Manual MODSTER Easy Trainer 800
2. The servo arms should all be at right angles. You can readjust using the transmitter's trim function. With computer transmitters, this can also
be done using the „sub-trim" or „servo centre" function. 3.
3. By default, the outermost hole of each lever is used, but you can also use the holes further inwards, which will increase the deflections and
make the model more aerobatic.
4. align the elevator and aileron in parallel by turning the clevises on the linkages either in or out. The clevises have small pins that must en-
gage the holes in the levers. Always open and close the clevises with care.
Note: Secure the clevises with a piece of silicone tube to prevent accidental opening.
Höhenruder
Elevator
Querruder
Aileron
30 www.modster.at