Table of Contents
Advertisement
Tyre inflation pressures
Tyre size
265/60R18 110H
Check the tyre inflation pressure of all the
tyres while they are cold; if insufficient or
excessive, adjust to the specified value.
After the tyre inflation pressure has been
adjusted, check the tyres for damage and air
leaks. Be sure to put caps on the valves.
NOTE
The tyres that can be installed on your vehi-
cle are shown on the driver's door label. For
details, contact an authorised MITSUBISHI
MOTORS dealer.
Up to 5 passengers
Front
Rear
2.0 bar
2.2 bar
(200 kPa)
(220 kPa)
{29 psi}
{32 psi}
Wheel condition
1- Location of the tread wear indicator
2- Tread wear indicator
Check the tyres for cuts, cracks and other
damage. Replace the tyres if there are deep
cuts or cracks. Also check each tyre for
pieces of metal or pebbles.
The use of worn tyres can be very dangerous
because of the greater chance of skidding or
Up to max. load or trailer towing
Front
2.0 bar
(200 kPa)
{29 psi}
hydroplaning. The tread depth of the tyres
must exceed 1.6 mm in order for the tyres to
E01001802007
meet the minimum requirement for use.
Tread wear indicators will appear on the sur-
face of the tyre as the tyre wears, thereby
indicating that the tyre no longer meets the
minimum requirement for use. When these
wear indicators appear, the tyres must be
replaced with new ones.
In the case of the 4-wheel drive vehicles,
when replacement of any of the tyres is nec-
essary, replace all of them.
Maintenance
Tyres
E01001404762
Rear
2.5 bar
(250 kPa)
{36 psi}
10
10-11
Advertisement
Table of Contents
