Brother HL HL-1060 Service Manual page 45

(5) After removing the sector gear, paper feed bearing, and bearing 6, take off the
paper pick-up roller unit.
Paper feed
bearing
Sector gear
(6) Raise the pressure plate toward you and press both sides of the pad inward to
release it by pressing the separation pad holder. Then take off the spring.
Note: If it is impossible to release the pressure plate in the above way, press the side of
the pressure plate (



Note: Be sure to replace the regist sensor actuator film together whenever replacing
the regist sensor actuator.
Fig. 3.7


) while pulling the side of the sheet feeder (
Separation pad holder
Fig. 3.8
III-6
<HL-1060> PR98062
Bearing 6
Paper pick-up
roller unit

).
Pressure plate
Separation pad
Spring