Mounting - Tripp Lite BP192V12RT3US Owner's Manual

Mounting (4-Post Rack)
Mount your battery pack in a 4-post or 2-post rack or rack enclosure, or in an upright tower position. The user must
determine the fitness of hardware and procedures before mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure. The procedures described in this manual are for
common rack and rack enclosure types and may not be appropriate for all applications.
4-Post Mounting
Most external battery packs include the hardware required for 4-post mounting. If this hardware did not come with your unit,
an Adjustable 4-Post Rack-Mount Shelf Kit (models: 4POSTRAILKIT or 4POSTRAILKITHD) may be ordered separately.
Install at a height not exceeding 1 m (3.3 ft.).
1 The included plastic pegs
mounting hardware. Insert a peg near the center of the front and rear bracket of each shelf as shown. (Each front
bracket has six holes and each rear bracket has three holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to match the depth of your rack rails. The pegs will fit through the square
holes in the rack rails to support the shelves. Refer to the rack unit labels to confirm the shelves are level in all
directions.
Note: The support ledge of each shelf must face inward.
1
2 Secure the shelves
B
screws in the rear) and cup washers
Tighten all screws before proceeding.
Warning: Do not attempt to install equipment until you have inserted and tightened the required screws.
The plastic pegs will not support the weight of your equipment.
C
2
will temporarily support the empty rack-mount shelves
A
A
to the mounting rails permanently using the included screws (six screws in the front and four
as shown.
C
B
C
A
B
A
C
B
4
while you install the permanent
B
B
A
C