Cardigo MARTEN SHOCK PRO Instruction Manual page 11

reduced physical, sensory or mental capabili-
ties, or the lack of experience or lack of knowl-
edge, unless they are supervised or have been
instructed in the use of the device by a person
responsible for their safety.
• Keep these instructions in a safe place and
pass them on when giving the device to a third
person.
4. Contents
• Marten shock Pro
• 3 cable shoes
• Warning sticker
5. Getting Started
The Gardigo Marder-Schock Profi is assembled in the engine compartment of the car.
The high voltage modules should be placed in areas where a marten will most likely
pass through. The device will automatically switch on when the ignition is off, and will
switch off when the ignition is on. The installation of the device should only be done
by a qualified person.
• If your car has already been visited by martens before, then it is quite likely that they
have marked their territory by leaving scent marks in the engine compartment. These
need to be eliminated before installing the device. We therefore recommend having
the engine thoroughly washed out before starting work.
• The animals will also leave their scent marks under the car e.g. on your parking space.
If you are parking regularly on the same spot we recommend cleaning the parking
place with a detergent.
• The Gardigo Marder-Schock Profi is installed in the engine compartment, make sure
that it is protected from spray water and dirt. It can be mounted with tapping screws
or cable ties. When installing make that the LED flashes [ ] at the top of the device
are not covered.
• Remove the fuse from the + cable [ ] when installing the device. This will protect
you from accidental short-circuits or electric shocks when touching the high volt
modules.
• 8 cable ties
• 4 fixing screws
• Instruction manual
11