gefran DIGISTAR II Installation And Operation Manual page 25

Installation of the PC104 boards
The motherboard has one slot for PC104 boards with the support towers already installed.
To install the card, insert it into the relative electrical and mechanical housings.
Fix the card using 4 towers, or if necessary 4 3ma nuts.
Any input/output must be installed using the spaces provided for the customs slots.
Turn on the system and install any drivers or software
provided by the manufacturer of the card.
Installation of PCI boards
The basic card has one slot for PCI boards
The system supports PCI boards with a maximum length of 150mm
For PCI installation:
• Remove the neutral cover.
• Install the card by inserting it into the relative electrical and mechanical housings.
• Fix the card using the screw provided.
• Power the system, when you start Access
the CMOS system SETUP (as described
in the following paragraphs) and, in the
menu "PNP/PCI Configuration", enable the
"Reset Configuration Data"
• Turn on the system and install any drivers of
software provided by the manufacturer of the
card
80544B_MHW_DIGISTAR II - DIGISTAR II Control - GF-BOX_02-2013_ENG
25