Initial Use - Tetra EasyCrystal Filter 250 Instruction Manual

UK
3. Hang the filter on a loop on the edge of the aquarium, paying
attention to the specified distances.
4. Press the suction cup against the aquarium wall until it is
attached.
Attaching the EasyCrystal Filter to a standard aquarium
Procedure:
Fig. C
1. Install both suction cups with short shafts.
2. Position the filter, paying attention to the specified distances,
and press the suction cups against the aquarium wall until
they are attached.

INITIAL USE

Important information
• The filter needs a run-in period of approx. 2 weeks. Do not
introduce any fish or plants during this time!
Tip: Tetra SafeStart (accessories) allows fish and plants to be
introduced as soon as the aquarium is set up.
• Before introducing fish and plants, check the water values,
for example with a Tetra test strip (accessories).
• Use only Tetra EasyCrystal filter cartridges.
• If you are adding medication to the water, you should use
Tetra EasyCrystal filter cartridges without activated carbon
because activated carbon absorbs many medications from
the water.
Switching the EasyCrystal Filter on/off
NOTE
The device is switched on when the plug is inserted into a
socket. It is switched off (no power) when the plug is pulled
out.
Procedure:
Fig. D
1. Insert the power supply plug in the socket.
– The lowest point of the power cable must be below the
socket to prevent any water dripping down from entering
the socket.
8
EasyCrystal Filter 250