Display (7-segment LCD) Error message(s) Cleaning Getting started Inserting a smart card (Touch ‘n Go card) 2.5.1 2.5.2 Checking the smart card balance Operating AUTO TAG, SET Operation 3.1.1 Debiting Process 3.1.2 Operational Features 3.1.3 Acoustic Signals Product / Device Specifications...
Refer servicing to qualified service personnel only. There are no user interactions required during operation The auto tag main box is solely intended for the use in a car. It is not suitable for the use on motorbikes, scooters or bicycles.
• Button Press to checking smart card balance Buzzer To inform the user about the operational state of the Auto Tag system Card Slot Inserting a smart card (Touch ‘n Go card) Display 6-digit liquid crystal display that informs the user about a number of operational states ...
Page 5
RUSH-JAN-2019-001 SECTION 2.0 Getting Started Display (7-segment LCD) The Toyota Auto Tag provides a 6-digit liquid crystal display that informs the user about a number of operational states. Infrared transmission indicator • Infrared receiving indicator Segment Figure 2.2 Error message(s)
Page 6
Caution: To avoid damaging the display or the case, do not use solvents or abrasive cleansers. Getting started The Toyota Auto Tag system is an electronic device used for electronic fare payment. Toll payments are carried out automatically without the need of interaction from the user (driver).
RUSH-JAN-2019-001 SECTION 2.0 Getting Started 2.5.2 Checking the smart card balance The balance of the smart card can be easily checked by pressing the button on the left of the display. Upon pressing the button, the balance of the smart card will be shown on the LCD display. Smart card balance is shown on the display Figure 2.5.2(a) If no smart card present in the card slot or the card was not initialised...
Operational Features The Toyota Auto Tag system comes with several key features. Low power feature The Auto Tag system is in a special low power “sleep” mode when not communicating (outside toll plaza area). Traffic Jam program In case of traffic jam at toll plaza, the car may spend a longer time at the communication zone of the toll gate.
Operational Features Time lock After toll payment operation is completed, the Toyota Auto Tag system will be locked for the specific toll plaza to avoid double deductions. However this lock time value depends on the system configuration (normal setting is approx.
RUSH-JAN-2019-001 SECTION 4.0 Product / Device Specifications Electrical Specification Nominal Voltage Operating Voltage 8V-24V Rated Voltage 13.5V IG-ON Voltage More than 7.0V ≤150mA Operating Current Output Current Less than 1.0 A (max 1.0A) Output Voltage 8.0V±0.2V -30⁰C ~+80⁰C Operation Temperature -40⁰C ~+85⁰C Storage Temperature Please read this manual for proper operation and keep it for future reference.
RUSH-JAN-2019-001 SECTION 5.0 Troubleshooting Simple Troubleshooting Situation Cause Action Auto Tag not functioning No electricity powering the Check if the power system connector is properly connected. Payment cannot be Little balance left on the Check smart card balance completed correctly inserted smart card.