Getting Started - VTech 2-in-1 Toddle & Talk Turtle Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the turtle. Use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA batteries following the diagram inside the battery
box. (For best performance, alkaline batteries or fully charged Ni-
MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
4