PACMotion™ Rotary Servo Motors Installation and User Manual
GFK-3169B
2.1.3
Flange
IEC flange accuracy according to DIN 42955. Tolerances of shaft extension run-out and of mounting
flanges for rotating electrical machines.
Code
K
C
D
G
E
B
2.1.4
Protection class
Standard Motor
IC830M2 - IC830M7
2.1.5
Insulation material class
The motors come up to insulation material class F according to IEC 60085 (UL1446 class F).
2.1.6
Surface
The motors are coated with polyester powder coating in matte black. This finish is not resistant against
solvents (e.g. trichlorethylene, nitro-thinners, or similar).
2.1.7
Shaft end, A-side
Power transmission is made through the cylindrical shaft end A, fit k6 (IC830M1: h7) to EN 50347, with a
locking thread but without a fitted keyway.
Motors are also available with keyway and inserted key according to DIN 6885. The shaft with keyway is
balanced with short (half) key.
Bearing life is calculated with 20.000 operating hours.
Order code
C
K
Technical Description
Flange
NEMA ICS 16 Metric Flange
NEMA ICS 16 Metric Flange
IEC 60072 Flange
IEC 60072 Flange
NEMA ICS 16 Metric Flange
NEMA ICS 16 Metric Flange
Shaft end
Keyway, closed
Keyway, open
Connector Option
9, B, C, H
Available for
IC830M
2...7
IC830M4
...7
Shaft Seal
Protection class
without
IP54
Section 2
October 2020
13