Threading The Machine; Winding The Bobbin - Brother XL-2230 Operation Manual

KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

THREADING THE MACHINE

Winding the Bobbin

CAUTION
●
Only use the bobbin (part code: SA156, SFB (XA5539-151)) that has been designed for this
sewing machine. Using of any other bobbin may cause damage to the machine.
●
We designed the bobbin that comes with this machine. If you use bobbins from older models,
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB (XA5539-151)).
1 Put the spool of thread on the spool pin and
pass the thread around the bobbin-winding
tension disc.
CAUTION
●
If the spool of thread is not in the right
place, the thread may tangle on the spool
pin.
Pass the end of the thread through the hole on
2
the bobbin from the inside of the bobbin.
18
11.5 mm
(7/16 inch)
This model
1
1Bobbin-winding tension disc
2Bobbin-winder shaft
Actual size
Older model
3 Put the bobbin onto the bobbin-winder shaft
and slide the bobbin-winder shaft to the right.
Turn the bobbin clockwise, by hand, until the
spring on the shaft slides into the groove of
the bobbin.
1 Spring on the shaft
2 Groove of the bobbin
2
2
1