Brother PE-300S Operation Manual page 21

1
2
2
1
18
5. Guide the thread through the small hole in the side of the bob-
bin from the inside. Align the groove in the bobbin with the
2
spring on the shaft and place the bobbin on the bobbin winder
shaft. While holding the thread end, push the bobbin winder
1
shaft to the right.
1 Spring on the shaft
2 Groove of the bobbin
6. Set the speed to minimum.
7. While holding the thread end, press the "START/STOP" but-
ton. Wind the thread a few times around the bobbin and press
the "START/STOP" button again.
Trim the excess thread from the top of the bobbin after the
machine stops.
8. Set the speed to maximum.
9. Press the "START/STOP" button. The bobbin will stop spin-
ning when bobbin winding is finished.
10. When the bobbin stops spinning, press the "START/STOP"
button to stop the sewing machine.
11. Push the bobbin shaft to the left. Remove the bobbin.