Pulling Up The Bobbin Thread - Brother NX-200 Operation Manual

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
Insert the bobbin into the shuttle.
1
1
• Refer to steps through
bobbin" (page 16).
Pass the bobbin thread through the slot.
2
Do not cut the thread with the cutter.
While lightly holding the upper thread with
3
your left hand, press
button) twice to raise the needle.
1 Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
4 Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
5
of "Installing the
(needle position
1
Pull out about 5 cm (2 inch) of the bobbin
5
thread under the presser foot toward the rear
of the machine.
Reattach the bobbin cover.
6
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
2
Upper Threading 25